arkayllb
Jun 11, 2007, 05:14 PM
These are very highly regarded hybrids made by one of golf's great club designers, Tom Wishon. Stiff graphite shafts (GI 335) made specifically for these club heads. These clubs are solid, solid, solid. Great feel, sound, ball flight, etc.
They are in very good condition (8.5+/10) with Golf Pride Dual Durometer grips. Length is just a bit longer than standard (less than 1/2 an inch), with standard lie and loft. Below are the features taken from www.wishongolf.com (http://www.wishongolf.com).
$100 for both. Sorry, at this pricing, not worth posting or sending around pics.
UPDATE: After pulling these out I realized I re-shafted the 3 iron with a steel rifle shaft (5.0). BUT I did save the graphite Wishon shaft - professionally pulled. I'll take $10 off and you can keep the steel shaft if you wish to re-reshaft with the graphite Wishon shaft. $90 total (two full clubs + one graphite shaft).
Features:
- Model 321Li hybrid long irons are the ultimate in true hybrid long iron design due to the accompanying design of the matching GI-335 graphite in stiff flex
- TWGT research has shown that the shaft can be a visible contributor to the launch angle, but only if the shaft is designed to bend/deflect an amount much greater than is typical with a conventional iron shaft. Typical iron shafts have a larger tip diameter which can only bend/deflect 1-2" in the swing. The GI335 and Series 5 Steel .335 shaft are designed with the same butt stiffness as a conventional iron shaft, but with a small tip design to increase the launch angle and trajectory of the shot
- 321Li full hybrid long iron heads are designed in a #1, 2, 3, 4, 5 and 6-iron. Matched with any set of irons, the 321Li offers golfers a much higher trajectory from the bending of the unique small iron tip design of the GI-335 and Series 5 Steel shafts
- 321Li full hybrid long iron heads are designed with a hosel to face position that is much more like a true iron for the proper appearance and set up at address
- A cross-section view of the wall thickness of the 321Li head design shows another reason for the easy playability of this model - the rear wall of each 321Li is extremely thick to pull the CG farther back from the shaft to further assist with increasing the launch angle of the shot
- 321Li full hybrid long iron heads are finished in an attractive dark grey metallic with bright satin highlights on the sole and toe/heel
They are in very good condition (8.5+/10) with Golf Pride Dual Durometer grips. Length is just a bit longer than standard (less than 1/2 an inch), with standard lie and loft. Below are the features taken from www.wishongolf.com (http://www.wishongolf.com).
$100 for both. Sorry, at this pricing, not worth posting or sending around pics.
UPDATE: After pulling these out I realized I re-shafted the 3 iron with a steel rifle shaft (5.0). BUT I did save the graphite Wishon shaft - professionally pulled. I'll take $10 off and you can keep the steel shaft if you wish to re-reshaft with the graphite Wishon shaft. $90 total (two full clubs + one graphite shaft).
Features:
- Model 321Li hybrid long irons are the ultimate in true hybrid long iron design due to the accompanying design of the matching GI-335 graphite in stiff flex
- TWGT research has shown that the shaft can be a visible contributor to the launch angle, but only if the shaft is designed to bend/deflect an amount much greater than is typical with a conventional iron shaft. Typical iron shafts have a larger tip diameter which can only bend/deflect 1-2" in the swing. The GI335 and Series 5 Steel .335 shaft are designed with the same butt stiffness as a conventional iron shaft, but with a small tip design to increase the launch angle and trajectory of the shot
- 321Li full hybrid long iron heads are designed in a #1, 2, 3, 4, 5 and 6-iron. Matched with any set of irons, the 321Li offers golfers a much higher trajectory from the bending of the unique small iron tip design of the GI-335 and Series 5 Steel shafts
- 321Li full hybrid long iron heads are designed with a hosel to face position that is much more like a true iron for the proper appearance and set up at address
- A cross-section view of the wall thickness of the 321Li head design shows another reason for the easy playability of this model - the rear wall of each 321Li is extremely thick to pull the CG farther back from the shaft to further assist with increasing the launch angle of the shot
- 321Li full hybrid long iron heads are finished in an attractive dark grey metallic with bright satin highlights on the sole and toe/heel