Hi,
I was recently handed down a 915H 24* but the stock shaft was cut down 1 inch which i find too short.
Wondering if I could use my 913H 21* stock untouched shaft into the 24* head.
Any issues? Was going to try it out today but forgot my tool at home.
Any feedback is appreciated.
Thanks!
I was recently handed down a 915H 24* but the stock shaft was cut down 1 inch which i find too short.
Wondering if I could use my 913H 21* stock untouched shaft into the 24* head.
Any issues? Was going to try it out today but forgot my tool at home.
Any feedback is appreciated.
Thanks!
Comment